While the data generated by a Kent Oil Meter can be read manually at the point of flow, in many applications today, the oil meter is a part of a complex instrumentation and control system. recognizing this, Kent Oil Meters are designed to interface with the electronic systems and for remote readouts. Following optional equipments are offered :

Pulse generator (PG 1)

It transforms the mechanical motion of the metre into a pulse signal. It requires a 12 to 24 volt power supply (Being supplied by remote totalizer) and it gives pulse output signal via three core table.

Remote Totaliser and Flow Rate Indicator (TF 200)

Pulse signal from PG1 can be totalized as well as rate of flow indicated by this unit with following features

FI Convertor (4 - 20 mA signal generator)

The pulse output signal from the pulse unit can be fed into FI converter and 4 - 20 mA signal is generated. This signal can be utilised for process controls. This can also be used as a parallel equipment with TF 200. The specifications are as under

Combined Batching, Totalizer and Rate of Flow Unit (BTF 200)

Combined with pulse generator, the unit totalises the flow of oil, indicates rate of flow and has two set points for dispensing of pre-determined quantities of liquids. With the help of this unit pre determined quantities of liquids can be transferred and automatic controls generated. Specifications are as under;

6 digit 0.3" LED display Displays total flow and rate of flow Size 72mm X 72mm X 120mm Case material ABS housing Weight 600 gms. Panel cut out 68 mm (H) X 68 mm (W) Number of set points 2 Reset arrangement via front panel and rear terminal Output two relays, 1 CO each, 5A @ 230 V AC/ 24 V DC

Kent Oil Meters : Click on any of the links below for further information

• Applications
• Features
• Specifications
• Selection & Installation
• Electronic Systems